|
Different
configurations of specimen holders add to the versatility of the
TABER Abraser (Abrader), and permits testing most any material. All holders
are interchangeable, and have been designed to lock in place yet
still be easily removed from the abraser (abrader).
A common
feature to most specimen tables is the clamp plate and nut. Mounted
on top of your specimen, these help keep flexible materials flat
and rigid materials secure. The rubber pad (S-19) ensures specimen
materials do not slip during testing.
E100-125; Specimen Holder [part# 120990]
Test all rigid, flat specimens of any material (standard specimen
holder included with all abrasers).
 E100-101;
Hold Down Ring (4 17/64" ID) [part# 125795]
Used for flexible materials up to 1/16" thick [use with E100-125].
E100-102; Hold Down Ring (4 21/64" ID) [part# 125796]
Used for flexible materials up to 1/16" thick [use with E100-125].
E100-10; Transparent Plastic [part# 121205]
Used for viewing textile specimens against a light source to determine
wear characteristics without having to remove the specimen from
the holder. (Can be used with E100-101 or E100-102).
E140-14; Ring Clamp Holder [part# 121155]
Eight (8) screws spaced evenly on the clamp plate allow you to test
slightly warped specimens (dry or wet). Furnished with (S) or without
(NS) center screw.
 E140-15;
Textile (Tensioning Type) [part# 121148]
Used for flexible materials. Incorporates a raised wear track to
provide extra tensioning to the material when the hold down ring
is drawn down over the edge of the holder and clamp plate is mounted.
Requires 5 ¼" circle of test material.
E140-18; Textile (Rimmed) [part# 121208]
Used for flexible materials. This holder provides an initial stretch
to woven fabrics, thereby minimizing their tendency to wrinkle if
they are tested moist.
E140-19; Drive Pin Type [part# 121207]
Used for rigid, square specimens without the need for a center hole.
Specimens are attached to this holder with S-37 or S-37-1 mounting sheets.
 E140-21;
Threaded Ring (NEMA) [part# 121206]
Used for slightly warped specimens, this holder incorporates a clamp
plate and flanged clamp ring. The clamp ring is threaded to the
body of the holder, which securely holds the outer edges of a specimen
up to 5 3/8" diameter.
E140-75; Rimmed Specimen Holder [part# 125604]
Used for wet testing materials. A 3/8" raised rim retains liquids,
allowing you to determine the effect of absorbed and or surface
moisture on abrasion resistance.
E-3945; Multiple Specimen [part# 121241]
Divided into eight (8) sections, this holder permits simultaneous
testing of lightweight, flexible specimens. Used primarily for nylon
hosiery and light fabrics.
S-19 Replacement Pads [part# 121016]
Rubber pads for specimen holders (4 ¼" OD)
S-21 Extension Nut [part# 121224]
Use this center nut to test materials ¼" - ½"
thick (requires a 3/8" center hole).
Arm Height Extension Kit [part# 132160]
This kit changes the position of the abraser arms to permit the evaluation of samples up to 40mm. A set of shims permits the user to maintain proper position of the arms relative to the test specimen. [Requires instrument to be returned]
|
